DIMMER PROFESSIONAL 1-10V
DM-PRO 1-10V

Dimmer DM – PRO 1-10V was designed to cover the needs of professional stores on basic sections of lighting.The modern design combined with the advantages of technology 1-10V, which is widening in the field of professional lighting, makes it unique. It is an absolutely safe to use and reliable product as it is constructed with special integrated circuits and tough plastic so it can function under adverse conditions.

Handling: DM – Pro 1-10V is controlled by a rotary potentiometer which controls the current and the power consumption to the desired level from 1% to 100%. The is also an embedded switch in the potentiometer (press switch) to activate and deactivate the device.


Lower level setting: DM-PRO 1-10V gives us the ability to pre-configure the minimum lamp brightness point if required. This process is accomplished by adjusting a potentiometer (trimmer) located inside the device.

This is done as follows:

  • Step 1: Set the main potentiometer at lowest setting.
  • Step 2: Meanwhile, remove the mask of the device (DM - PRO 1-10V) and then set the potentiometer which is inside the dimmer (ADJ) to the lowest allowed desired limit.
  • Step 3: Repeat the same procedure in order to reset the lowest limit.
Note :
a) Highest setting of lowest limit is 50%.
b) After the procedure’s completion (lowest limit setting) dimmer forbids us to reduce the power of electric load more than the presetting. However it allows us to increase it up to 100%.

Download the DM-PRO 1-10V manual


Technical Specifications

DIMMER: Electronic 1–10V
OPERATION: Soft Start
OPERATING VOLTAGE: 230Vac
OPERATING FREQUENCY: 50Hz 
OUTPUT SIGNAL: 1-10V / 50mA
FUSE: 6,3 A (for short-circuit protection)
ENVIRONMENT TEMPERATURE: -20°C to +50°C 
WIRE SIZE: From 0.5 mm² to 3.5 mm²
MOUNTING: Surface – mounting
CONTROL LOAD: Drivers - Controllers - Electronic Ballasts with 1-10V protocol
SETTING: Rotary Potentiometer
LOWER LIMIT SETTING: Internal Potentiometer (trimmer) 


EUROPEAN COMMUNITY DIRECTIVES:


The product complies with directives:
Low Voltage Directive: 2014/55/EU
EMC Directive: 2014/30/EU
EN 60669-1
EN 60669-2-1

Draft of Electrical Installation

3D Preview

Watch the three-dimensional representation of the product by long pressing click